Page 28 of 41
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Sun Jun 26, 2022 9:04 pm
by Thibo946
PaulNathan, je suis français aussi, ouvre tes DMs
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Mon Jun 27, 2022 12:17 pm
by simonsais
thank you for your previous answers! i ordered this controller/esc:
https://de.aliexpress.com/item/10050027 ... pt=glo2deu
i hope it works good. and if not, is there a way to PID tune the esc?
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Tue Jun 28, 2022 10:44 pm
by Jevako030
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Wed Jun 29, 2022 5:28 am
by dijkie
ok, but then it should be able to find a Hall sensor that fits ... ?
think it will solve the grinding noise and gives a smoother ride
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Wed Jun 29, 2022 11:06 pm
by Jevako030
I think so too, but it's not easy because of the right Hall sensor. You do have sets of 3 on a print.
https://nl.aliexpress.com/item/10050039 ... 9323%21rec
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Sat Jul 02, 2022 9:31 pm
by Jevako030
dijkie wrote: ↑Wed Jun 29, 2022 5:28 am
ok, but then it should be able to find a Hall sensor that fits ... ?
think it will solve the grinding noise and gives a smoother ride
I'm just going to try to put 3 hall sensors in it. This week I will open the hub motor again to measure the correct dimensions and see if it fits in it, also to pull a separate cable for it. I do take pictures of the dimensions and which ones can be ordered at the Ali Express.
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Thu Jul 07, 2022 11:02 pm
by FlapjackStaxx
how do you get both sides of the motor off? I can only get one
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Sat Jul 09, 2022 11:03 am
by Jevako030
Disconnecting the motor proceeds as follows.
1: Loosen bolts.
2: Place the motor on the shaft where the cable comes out, then lift it slightly and press it hard, then hear and see that the magnets release and you can easily remove it. Make sure that the screw thread is not damaged and the cable does not kink.
Place it on an edge of a table so that you create space for the cable.
Put it back, lower the magnet slowly and then it will pull itself.
There is a thin gold colored ring around the shaft, make sure that it is not loose around the shaft because otherwise it will get stuck and bend and guide the cable well so that the rubber connects again (see photo). because it goes very fast with a lot of power.
Good luck.
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Sat Jul 09, 2022 1:28 pm
by FlapjackStaxx
Excellent thank you!
Re: New Lime Gen4 (V2) - Okai ES400A
Posted: Mon Jul 11, 2022 6:14 am
by simonsais
wd40 + chisel works perfectly fine to release the security nuts