An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Covers electric scooter models whether shared or for consumers.
#21010
What a opportunity that had to be to get a insider glimpse of a garage / storage facility let alone a inside look at the tools used. I thought about giving such a opportunity a run but figured it wouldn't be for the money it would of been for other motives so I passed the thought off. I have alot of scooters mostly all that I've pieced together from ones ripped In half or floating in a stream and im actually not even interested in the Scooters exactly as my interest is primarily hacking, manipulating, reusing, bypassing or just any sort of way to decode the Iot devices (internet of things?,(pay to ride gps box).

#21049
[email protected] wrote:
Sun May 17, 2020 6:24 pm
What a opportunity that had to be to get a insider glimpse of a garage / storage facility let alone a inside look at the tools used. I thought about giving such a opportunity a run but figured it wouldn't be for the money it would of been for other motives so I passed the thought off. I have alot of scooters mostly all that I've pieced together from ones ripped In half or floating in a stream and im actually not even interested in the Scooters exactly as my interest is primarily hacking, manipulating, reusing, bypassing or just any sort of way to decode the Iot devices (internet of things?,(pay to ride gps box).
When they give u the chargers you have to go to pick them up from a Lime garage. then i told them i was interested in the mechanic job as well( i was not of coz) so they gave me a tour around the place.


#21613
I use a Raspberry Pi and OpenOCD to read/write to the flash on the Lime 2.5 (my ST-Link hasn't arrived yet)
The main 'chip' is a MKE02z64, it is part of the Kinetis KE02 family using a Cortex-M0+
There is a 5 pin plug (unused) coming from the controller, this is a SWD connection.

I would like to see the schematic for the controller if anyone has some laying about To view images REGISTER or LOGIN for full access.

LiquidSky wrote:
Sun May 17, 2020 5:43 pm
[email protected] wrote:
Sun May 17, 2020 5:08 pm
What scheme sheet are you talking about?
Controller schematics(it includes pcb as well).

Also what is needed for direct connection to the he lime 2.5? St-link? Or is there a diy jig that can be assembled to connect directly to PC.

St-link is a must. prbbly there r some DIYs but i only saw these at lime garage/storage.

#22145
I have question about battery. It's 2.5 battery BMS. How can I use it to build my own configuration (also 10s3p)?
There is almost all as normal, like b1, b2...b8. But b9 is in other place and have 2 wires (b9+1 & b9+2). Maybe it's for connecting same wire but from other places?

I want to use this BMS to build my own. How can I connect it? Can anyone draw a simple plan?


  • 1
  • 127
  • 128
  • 129
  • 130
  • 131
New Bolt Scooter

Bolt scooters in Polen https://i.imgur.com[…]

Identify and use this Controller

Obvious: +5V, 36V, VCC BATIN+, BATIN- GND Probab[…]

It is actually possible to use an esx dashboard […]

Hi. My g30 controller looks diffrend. Its a orig[…]