- Sat Dec 15, 2018 8:08 pm
#2966
I'm thinking about this and comparing to the motherboard that I found in this ES2 Lime variant
Analyzing the option of use an original dash and motherboard (stock) re wiring to use with this model cable interface and I think it's very possible.
Looking your info and pictures and comparing it with mines I found this.
a. In the original motherboard the outputs going to the motor and lights are this.
1. Red arrows. Three big cables (BLUE;BROWN;YELLOW) to the motor.
2. Blue arrow. 5pin connector (RED;BLUE;GREEN;YELLOW;BLACK) would be the motor's electronic controls.
3. Green arrow. 4pin connector (RED;GREEN;YELLOW;BLACK) could be for rear lights.
Now...
In this ES2 Like variant we found just 2 cables going down. Numbers 2 and 5
So, this two cables must "resume" the same info and power, or similar at least.
If we look in detail this two we can see this...
Green arrows indicate the three big cables pointed in number 1 in the picture up (going to power up motor)
Pink arrows indicate the 5 cables pointed in number 2 upper picture (electronics control of motor)
Blue arrow indicate just three cables going to the lights. Just three cables for the back light because this variant don't have led under the pedal.
Have sense?
John_Doe_1337 wrote: ↑Thu Dec 13, 2018 7:03 am
EDIT:
Wait no that was pure nonsense. The capped bit is 5pin, not compatible with the blue 4pin seen on the control unit.
This is where you would be plugging the five cables coming out from the unit. At the bottom of the tube.
The three big cables (BLUE;BROWN;YELLOW) go from the motor to (I guess) the battery.
The 5pin connector (RED;BLUE;GREEN;YELLOW;BLACK) would be the motor's electronic controls.
The 4pin connector (RED;GREEN;YELLOW;BLACK) could be for rear lights.
I'm thinking about this and comparing to the motherboard that I found in this ES2 Lime variant
Analyzing the option of use an original dash and motherboard (stock) re wiring to use with this model cable interface and I think it's very possible.
Looking your info and pictures and comparing it with mines I found this.
a. In the original motherboard the outputs going to the motor and lights are this.
1. Red arrows. Three big cables (BLUE;BROWN;YELLOW) to the motor.
2. Blue arrow. 5pin connector (RED;BLUE;GREEN;YELLOW;BLACK) would be the motor's electronic controls.
3. Green arrow. 4pin connector (RED;GREEN;YELLOW;BLACK) could be for rear lights.
Now...
In this ES2 Like variant we found just 2 cables going down. Numbers 2 and 5
So, this two cables must "resume" the same info and power, or similar at least.
If we look in detail this two we can see this...
Green arrows indicate the three big cables pointed in number 1 in the picture up (going to power up motor)
Pink arrows indicate the 5 cables pointed in number 2 upper picture (electronics control of motor)
Blue arrow indicate just three cables going to the lights. Just three cables for the back light because this variant don't have led under the pedal.
Have sense?