By dehdon - Tue Nov 01, 2022 7:04 pm
- Tue Nov 01, 2022 7:04 pm
#57287
Hey guys,
I've been trying to piece together a scooter from spare parts, but I think I 've reached the limit my tinkering can achieve.
After much turmoil, I've got the controller powered, motor and throttle wired up, and can even spin the wheel for a few seconds.
Problem is:
I managed to get it to power up by twisting together the tx, rx, etc. wires:
Throttle is wired into controller directly:
Visual overview of where I'm at:
Anyone know how I could set it to the highest speed setting without a dashboard?
And anyone know why the motor cuts out after a few seconds?
Cheers guys
I've been trying to piece together a scooter from spare parts, but I think I 've reached the limit my tinkering can achieve.
After much turmoil, I've got the controller powered, motor and throttle wired up, and can even spin the wheel for a few seconds.
Problem is:
- 1. The motor only spins for a few seconds then cuts out.
2. It's stuck on the first speed setting.
I managed to get it to power up by twisting together the tx, rx, etc. wires:
Throttle is wired into controller directly:
Visual overview of where I'm at:
Anyone know how I could set it to the highest speed setting without a dashboard?
And anyone know why the motor cuts out after a few seconds?
Cheers guys