I've successfully installed this controller
- Battery to controller (please note that the thinner red cable on the power line is the ignition on. I've bridged with the other red cable that goes to the battery, it won't work otherwise);
- PHASE cables;
- Haul cables;
- Original throttle 3 cables.
- The battery has his own plug to be recharged;
- I don't have a display so I can't say what was the maximum speed, but I would say I was afraid to fall;
- I've applied thermal paste inside this controller and bridged the regenerative bridge hole to GND (but it probably doesn't work anyway);
- To make a better job I've cut all the cables from the original controller and soldered to the new one, so it's plug-n-play;
- You will need to spend some time with a tester to understand how to connect the throttle, as the cable that bridges it from the top to the ground has weird color code, as it transports also the brake cable (which I haven't connected anyway). From the throttle to this cable the color code is correct anyway, so you don't need to discover the functions of them.
- The controller doesn't fit inside the original hole, I will try something later.
- No lights wired yet, as I recall the power conversion happened on the mainboard, later on I will try to see whether I can grab some 3,3 (headlight), 5 or 12V in the BMS.