By TimInOz - Tue May 26, 2020 7:25 am
- Tue May 26, 2020 7:25 am
#21172
1. What end of the charger port do I remove to get it out of/ into the scooter:
A) The round end that just out of the scooter: detach the two wires that go into it?
OR
B) The square end that connects inside the scooter - somehow get the prongs out of it?
2. How do I do it?
There is just no way to remove the assembly out of the scooter whole - the hole on the chassis where the port comes out is too small and there is no other spot.
See pictures: note that the charger port I bought (and the one in there right now) both have the white bit attached.
_________________________________________________
BACKGROUND:
* I'm replacing the 2-port charge port that comes with the Rad2Go Scooter with a 3 port
* This is because I found it very difficult to get a 2-port charger, 24 volts (esp with up to 3.6 amps)
A) The round end that just out of the scooter: detach the two wires that go into it?
OR
B) The square end that connects inside the scooter - somehow get the prongs out of it?
2. How do I do it?
There is just no way to remove the assembly out of the scooter whole - the hole on the chassis where the port comes out is too small and there is no other spot.
See pictures: note that the charger port I bought (and the one in there right now) both have the white bit attached.
_________________________________________________
BACKGROUND:
* I'm replacing the 2-port charge port that comes with the Rad2Go Scooter with a 3 port
* This is because I found it very difficult to get a 2-port charger, 24 volts (esp with up to 3.6 amps)