By LAskooter213 - Sun Nov 17, 2019 10:35 pm
- Sun Nov 17, 2019 10:35 pm
#17463
Ok. So Ive got a Bolt Scooter (48 volt/35- watt) motor hooked up to a M365 controller on my test bench. The controller is flashed to CFWW, russian throttle alg. no kers, spped limit removed and flashed to operate on 60 volts. I have a 52 volt battery powering the controller.
Im figuring out the phase wires and it runs with two different configurations. In one configuration the motor works smoothly but only spins between 210-220 rpm even at full throttle. BORING. In the other configuration it actually accelerates but it ends up spinning so f**king fast it flings the tire off of the rim. It is out of f**king control fast. So much so I am certain it will lead to me eating asphault if I try to ride the scooter like that.
Does anyone know why this is happening? Im going to try to figure it out but just curious if anyone out there can give your big homie LASkooter an easy answer??! I think I deserve it.
So if any of yall know your sh*t hollar at a real one and lemme know. Thank you. Hope everyone out there is doing well on this lovely Sunday evening.
Im figuring out the phase wires and it runs with two different configurations. In one configuration the motor works smoothly but only spins between 210-220 rpm even at full throttle. BORING. In the other configuration it actually accelerates but it ends up spinning so f**king fast it flings the tire off of the rim. It is out of f**king control fast. So much so I am certain it will lead to me eating asphault if I try to ride the scooter like that.
Does anyone know why this is happening? Im going to try to figure it out but just curious if anyone out there can give your big homie LASkooter an easy answer??! I think I deserve it.
So if any of yall know your sh*t hollar at a real one and lemme know. Thank you. Hope everyone out there is doing well on this lovely Sunday evening.