[Scootermansussex]

Anyone figure out how to use the battery without cracking it open

[Scootermansussex]

Wish me luck I going to try feeding a small fibre glass rod dow the side of the BMS and cutt round the edge with dental floss an the hopefully slide pack out

[Scootermansussex]

Got this far

[Scootermansussex]

Didn't use fibre glass rod ended up using the angle grinder

[Scootermansussex]

Am thinking of trying to switch on past the canbus probably going to be difficult but think worth a go

[Scootermansussex]

Anyone connect to Rx and TX ?

[Scootermansussex]

It's alive

[UgloBuglo]

It's alive

What did you do? Bypass the BMS?

[Scootermansussex]

Elo mate I just disconnected the BMS negative out and put the wire on the negative battery terminal next to it all charges go through BMS so all good and I keep a eye on battery voltage make sure it don't drop below 42v . I will fit a BMS but was eager to test it

[Scootermansussex]

If u didn't want to fit a BMS u could just nip the corner of pack off and swap wires round and would look a lot cleaner also could be re waterproofed with silicone