By basti256 - Thu Dec 05, 2019 5:35 am
- Thu Dec 05, 2019 5:35 am
#17887
Hey guys,
i'm very sorry to only have a few minuted a day to give an Signal from me... I'm till the rest of the day more til end of january completely booked with work and other stuff. I am very sorry for that.
Actually I don't have time to proceed with the next version with the nfc reader. I think I am not gonna release the next version on friday... 1 or 2 weeks more I think I will need...
thanks for your feedback. It's a bit weird but it's possible that I've made an mistake during the compiling or in the sketch...
Normal procedure would be: Connect the module with the scooter, the arduino boots but the scooter stays "shutted off", if you have connected the RX line on the arduinoyou can see already something incoming. then you'll press the button (in my case it's the original reset button from the gps module) and after ~1 second you will hear an sound from the speaker.
The scooter will turn directly after the sound on.
When you press the button again you will hear the "turn off" sound and the scooter should immideately turns off.
Maybe I made an mistake, could YOU please try this attached version then I can refresh the package this evening or tomorrow. The only change in this scipt is the arduino "progmem" command i had some struggles at the beginning, but without a change it worked for me but maybe it's an general problem or an compiler probolem here... I've change the progmem command against an "const char".
Looking forward to hear from you.
i'm very sorry to only have a few minuted a day to give an Signal from me... I'm till the rest of the day more til end of january completely booked with work and other stuff. I am very sorry for that.
Actually I don't have time to proceed with the next version with the nfc reader. I think I am not gonna release the next version on friday... 1 or 2 weeks more I think I will need...
Hey Rick,Rick Sanchez wrote: ↑Wed Dec 04, 2019 8:38 pmIs it just me beeing morty or does anyone else have problems getting rev 0.2 to work also? I tried to flash the machine code Hex several times changing between my source, rev0.1 and rev0.2 but the latest one doesnt boot the scooter. I checked the output with a logicanalyzer but it is just putting out empty 00 hex bytes and repeating 6 of them over and over again. My scribt and rev0.1 do still work on my nano rev0.2 doesn't tickle the speaker also, it is just switching between TX line state "continious high" and repeating 6 "00" Hex bytes by pressing the button. @basti256 any Ideas?
thanks for your feedback. It's a bit weird but it's possible that I've made an mistake during the compiling or in the sketch...
Normal procedure would be: Connect the module with the scooter, the arduino boots but the scooter stays "shutted off", if you have connected the RX line on the arduinoyou can see already something incoming. then you'll press the button (in my case it's the original reset button from the gps module) and after ~1 second you will hear an sound from the speaker.
The scooter will turn directly after the sound on.
When you press the button again you will hear the "turn off" sound and the scooter should immideately turns off.
Maybe I made an mistake, could YOU please try this attached version then I can refresh the package this evening or tomorrow. The only change in this scipt is the arduino "progmem" command i had some struggles at the beginning, but without a change it worked for me but maybe it's an general problem or an compiler probolem here... I've change the progmem command against an "const char".
Looking forward to hear from you.
Attachments
(6.03 KiB) Downloaded 516 times