By 365GUY - Sat Jun 27, 2020 8:21 pm
- Sat Jun 27, 2020 8:21 pm
#21644
I can’t seem to find the bottom plate spacer for the MAX like the ones for the M365 to allow for more space in the battery compartment.
Does anyone have a 3D printer and the ability to design a similar spacer for the Max battery tray ?
It would need to be a 1/2” thick to allow for a 14s/6p pack. I’m not running any stock Ninebot controller , just a Flipski 4.12 VESC so I have a lot of room but need more to hold this large battery.
Currently it fits fine with a 14s/3p but I want to double up on capacity.
Anyone down to design this and sell me a few ?
You would be the only person selling them, there had to be other people who need these.
Let me know. Thx
Does anyone have a 3D printer and the ability to design a similar spacer for the Max battery tray ?
It would need to be a 1/2” thick to allow for a 14s/6p pack. I’m not running any stock Ninebot controller , just a Flipski 4.12 VESC so I have a lot of room but need more to hold this large battery.
Currently it fits fine with a 14s/3p but I want to double up on capacity.
Anyone down to design this and sell me a few ?
You would be the only person selling them, there had to be other people who need these.
Let me know. Thx