- Fri Aug 14, 2020 5:27 pm
#22669
Idk how to find it but without that you can use it only with an arduino that emulate the gps board on the rental firmware.
There is a special key to unlock uart flashing on snsc 2.3Aquaman wrote: ↑Thu Jun 25, 2020 12:49 pmI have flashed BLE/DASH to 1.1.0_FULL
Could connect without IOT-BOX but it didn't recognize anything.
When connecting with IOT-box in parallel, it didn't recognize the model but told me:
DRV 3.3.7
BMS 3.5.6
Where did you connect TTL-serial, did you hook it up in parallel with IOT-BOX?
In what order do you flash, DRV(ESC) and BMS?
I just get connection timed out if I try to flash any of the DRV(ESC) fw, And write length out of range if I try to flash the BMS
Any tips, Please?
Idk how to find it but without that you can use it only with an arduino that emulate the gps board on the rental firmware.