An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Changing mobility one trip at a time.
#53693
Hello, I have an ES200G bike and for 3 weeks I have been trying to get it up and running. I use Arduino nano. I've tried all the codes and found them involved. read the forum several times and still nothing. can someone please advise me how to connect arduino and what codes to use. Thank you. I apologize for English, I'm Czech.
Augi liked this

#53694
Hello, I have an ES200G bike and for 3 weeks I have been trying to get it up and running. I use Arduino nano. I've tried all the codes and found them involved. read the forum several times and still nothing. can someone please advise me how to connect arduino and what codes to use. Thank you. I apologize for English, I'm Czech.



#54060
MrSpriggs1 wrote:
Wed Jul 28, 2021 1:20 pm
The way the ES-400 communicates is fundamentally different from the ES-200. The ES-400 uses CAN like system (i.e. same as a car), ES-200 uses a simple serial interface. There was a guy named Rick Sanchez on here working on it. Maybe he got it working on the ES-400.
I saw you had the ES-200 controller apart can you share the pinout order of it I'm wanting to test a downgrade for the controller I can't find it online.

#54084
Micha1807 wrote:
Sat Jul 17, 2021 10:38 am
Hello, I have an ES200G bike and for 3 weeks I have been trying to get it up and running. I use Arduino nano. I've tried all the codes and found them involved. read the forum several times and still nothing. can someone please advise me how to connect arduino and what codes to use. Thank you. I apologize for English, I'm Czech.
(ENG)
Hi Micha1807.
I success unlock the scooter, lights is on, display is on, but the throttle nothing do....
Display don't say any error code. When I disconnect connector of throttle, say error. The cable is maybe ok. any ideas?
Please help Mans..

Thanks for reply.

(CZ)
Zdar Micha1807
Já jsem úspěšně odemknul koloběžku, světla svítí, displej také, ale plyn nereaguje.
Displej neukazuje žádnou chybu, když odpojím konektor plynu, ukazuje to error. Tudíž kabel zdá se být ok. Nějaké nápady?
Prosím chlapi pomozte mi,

Díky za odpověď




#54488
Hello,

i have a MyTier Scooter(ES-200G) and all i am trying it shuts Down (Erroe 00E) after 1-2 Minutes and i have to Full Reset the Scooter (Unplug controller) to get it alife.

I tried several Solutions. Arduino or Parrot. And alot of Codes.

Did someone have a Solution of it? Maybe Firmware Downgrade?

  • 1
  • 71
  • 72
  • 73
  • 74
  • 75

https://i.imgur.com/FCOBNTa.jpg https://i.img[…]

NEW BIRD ONE - MODEL 590

Not to spam but this is an update. I finally got t[…]

Bird 2

I will order the parts. Is just m365 pro enough?

Tier ES400 unlock development

These keys are for different locking-mechanisms.