- Sat Oct 09, 2021 1:34 pm
#55682
Hi, I was wondering if there is a good soul that want’s and know how to 3D model parts to help me. I need spacers for bird 2.
I’m in making of a Bird 2 V.2, where the scooter has AWD and 1512 Wh battery ( 120 cells) it is approximately 3.5 cm deeper than the orginal cover. Im going to cut off the battery compartment, so that there is more room. So all I need is spacers and that top cover part for the assembly.
I’m using a spintend dual esc controller,
Now i know that making spacers that big can let water inside, but I’m not planing on using it in heavy rain and all the adjustments needed with screws and silicone is going to be done.
I just need a pro who knows how to model to help me.
The end result Is a absolutely monster with, AWD that eats steep hills for breakfast.
It should be a 21 Ah battery, whitch should easily carry a AWD system, with same or bit less range.
If I get the help I need I will absolutely document everything, and help the next person who wants to make a crazy - death build.
I’m in making of a Bird 2 V.2, where the scooter has AWD and 1512 Wh battery ( 120 cells) it is approximately 3.5 cm deeper than the orginal cover. Im going to cut off the battery compartment, so that there is more room. So all I need is spacers and that top cover part for the assembly.
I’m using a spintend dual esc controller,
Now i know that making spacers that big can let water inside, but I’m not planing on using it in heavy rain and all the adjustments needed with screws and silicone is going to be done.
I just need a pro who knows how to model to help me.
The end result Is a absolutely monster with, AWD that eats steep hills for breakfast.
It should be a 21 Ah battery, whitch should easily carry a AWD system, with same or bit less range.
If I get the help I need I will absolutely document everything, and help the next person who wants to make a crazy - death build.