- Wed May 11, 2022 7:47 am
#56673
The LED in the steering wheel is RGB and I have connected it to a mini RGB control and now it constantly changes color.
I'm going to confirm the touch button in the original display and from there I turn everything on or off. I hope because I'm still testing it.
For the battery eject I have attached an up and down switch and can thus electrically remove the battery
I also have a driver between 5 modes, the light can also blink.dijkie wrote: ↑Tue May 03, 2022 11:40 amyellow/black gives about the battery voltage.
but it is limited in current, the lighting is LED, these need a current source.
as protection i now installed a LED driver for 350mA.
in my controller you cannot set the current.
the motor can deliver 200W, with 36V that is about 6 Amps
Hall sensors should work, at least the controller gives the correct speed in the display when driving.
i haven't taken the motor apart, only opened it to count the magnets.
The LED in the steering wheel is RGB and I have connected it to a mini RGB control and now it constantly changes color.
I'm going to confirm the touch button in the original display and from there I turn everything on or off. I hope because I'm still testing it.
For the battery eject I have attached an up and down switch and can thus electrically remove the battery