An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.
Where and how to flash the bms?Andrew0135 wrote: ↑Sat May 28, 2022 9:23 amAlways flashAquaman wrote: ↑Thu Jun 25, 2020 12:49 pmI have flashed BLE/DASH to 1.1.0_FULL
Could connect without IOT-BOX but it didn't recognize anything.
When connecting with IOT-box in parallel, it didn't recognize the model but told me:
Where did you connect TTL-serial, did you hook it up in parallel with IOT-BOX?
In what order do you flash, DRV(ESC) and BMS?
I just get connection timed out if I try to flash any of the DRV(ESC) fw, And write length out of range if I try to flash the BMS
Any tips, Please?
flash the BLE from 3 pin on the display dashboard with ST-Link
flash the BMS with CP2102
flash the ESC from Speed Control and ST-link
Jimmyyahoo wrote: ↑Wed Aug 03, 2022 2:13 amFlash BMS with Stlink, it's an STM8. Use STVP, download the .hex firmware from GitHub in the scooterhacking repo. Pinout should be standard, starting from square pad, 3.3vcc, swim, GND, and reset. PRACTICE YOUR SOLDERING SKILLS. Use good solder and a good iron with a clean tip. It can be done,.I just knocked out two of em (snsc2.3 conversions). It's not perfect, there are kinks to work out, but you can and will get a rideable scooter if you are halfway intelligent, can parse the info that's here, or ask informed questions. I will help anyone who is actively trying, not just looking for soft food I had to chew.
I flashed my bms with bms134_fulldump and till now it's workingPlandyPedals wrote: ↑Fri Aug 12, 2022 11:23 amPerfect! i have the Dash flashed already ... still working on how to connect extract the BMS from the caseing and which file to use for the BMS.
How did you Connect to the BMS? IAP or with STM link? and if STM link then what was the pinout?Dennnisffm wrote: ↑Sat Aug 13, 2022 5:24 amI flashed my bms with bms134_fulldump and till now it's workingPlandyPedals wrote: ↑Fri Aug 12, 2022 11:23 amPerfect! i have the Dash flashed already ... still working on how to connect extract the BMS from the caseing and which file to use for the BMS.
BMS still works for charging and u can look at vol[…]
Hi All, Just wondering If ya all got any teardown,[…]
Alright mate could you be abill to do that bypass […]
I got the battery out of the casings, and I didn't[…]