An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Enjoy the juice
#57041
memetrader wrote:
Thu Jun 16, 2022 4:29 pm
is the tutorial for how to downgrade these chips released? no way would anyone actually MAIL and pay this idiot to flash the chip.
I have a lime s 2.5j on the santa FW 2.4.26, where the old posted enable codes no longer work. Looking for a way to use an arduino MEGA to send enable codes directly to the motor controller.
Hi, did you find a solution for DIY downgrade? Thank you in advance
#57380
memetrader wrote:
Thu Jun 16, 2022 4:29 pm
is the tutorial for how to downgrade these chips released? no way would anyone actually MAIL and pay this idiot to flash the chip.
I have a lime s 2.5j on the santa FW 2.4.26, where the old posted enable codes no longer work. Looking for a way to use an arduino MEGA to send enable codes directly to the motor controller.
Good luck getting the old firmware to downgrade so the old hack works and to flash the chip with the firmware you need a Raspberry Pi Zero and a custom modded software.

As this was a rental version whos overstock was […]

Any one got any info on beryl bikes I seen a few[…]

LH/ TF-100 Style Display.

Hi I recently converted a Bird Zero to a personal […]

How do you operate dash without button? I have[…]