By LAskooter213 - Wed Apr 10, 2019 3:49 am
- Wed Apr 10, 2019 3:49 am
#7063
I currently have an M365 scooter with a stock wheel up front and a zero wheel custom installed in the back. The configuration is awesome, it chirps when you hit the throttle and you can pop wheelies no problem:) The scooter accelerates super fast and has torque to go uphill without slowing down at all but the damn thing still only gets up to around 20 mph and the power kind of fades in and out. I am currently running 2 controllers both flashed with the cfw 1000w firmware. So, i have 2 questions...first does anyone know how to increase the top speed? I know there is provisions for that in the custom firmware generator but they still do not let the motors wind up to their full potential. Back emf issue? i dont think it is. Mecanical limitation of the motor? No way, its got more in it. Electronic limitation of the controller? Possible but again i think its capable. I think the issue is in the firmware but cannot be sure. Any insight is appreciated.
Also, might over volting it do the trick? I see a provision in the firmware generator and the controller has a 60v capacitor so i know it can take 52-56 volts without blowing up. Again any info is appreciated.
Also, might over volting it do the trick? I see a provision in the firmware generator and the controller has a 60v capacitor so i know it can take 52-56 volts without blowing up. Again any info is appreciated.